[Healeys] Exhaust hanger in compression
Oudesluys
coudesluijs at chello.nl
Mon Nov 23 02:35:40 MST 2009
This is a far better construction than the rubber in tension. However if
you move the bracketery to the rear edge of the floor pan, you can make
the brackets simpler and with much more space to work on, L bracket to
the vertical part, U bracket to the exhaust pipe with the rubber in
between. You would also have more space for the exhaust pipe to move about.
Kees Oudesluijs
NL
>
> On Sun, Nov 22, 2009 at 12:19 PM, Steve B. Gerow <steveg at abrazosdata.com>wrote:
>
>
>> Following up on some ideas expressed here, I redid my broken exhaust
>> hangers today. The rear one I changed to act in compression rather than
>> tension, in order to provide additional safety in the event of rubber
>> failure.
>>
>> Pic at: http://www.pbase.com/stevegerow/image/119598505
>>
>>
>> --
>> Steve Gerow
>> Pasadena, CA
More information about the Healeys
mailing list