[Healeys] Tachometer wiring BJ8

BJ8Healeys sbyers at ec.rr.com
Mon Mar 30 11:40:25 MST 2009


Wes, the spade connection takes the green wire from the harness (it comes
from the fuel gauge).  The white wire makes a loop at the tach (it goes
through a plastic block which is secured to the tach by a small nut).  Make
sure the metal flat-bottomed U-shaped clip goes over the plastic block
before you screw on the nut.  See the attached photos.  The machine screws
just hold the tach together.

Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC  USA



-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of Weston Keyes
Sent: Monday, March 30, 2009 1:16 PM
To: Ahealey Ahealey
Subject: [Healeys] Tachometer wiring BJ8

Hello Folks,

    I am wiring up a Tach that I didn't disassemble. I see a male spade
connection on the back of the case and on the opposite side of the tach I
see
a brass machine screw. Both connect to electrical components inside the
tach.
>From the wiring diagram it looks like one white wire goes to the coil and
the
other to the ignition switch. Which wire goes to which terminal?

Many thanks

Wes Keyes
York, Maine

[demime 1.01d removed an attachment of type image/jpeg which had a name of tachometer white wire loop routing - labeled.jpg]

[demime 1.01d removed an attachment of type image/jpeg which had a name of tach screws.JPG]

[demime 1.01d removed an attachment of type image/jpeg which had a name of Tachometer - back, labeled.jpg]


More information about the Healeys mailing list