[Healeys] Rear Hub Issue

[Awgertoo at aol.com]

In a message dated 12/27/2009 10:19:06 A.M. Eastern Standard Time,  
eschulz at frontiernet.net writes:

"the  outer face of the bearing spacer should protrude from .001" to .004"
beyond  the outer face of the hub AND THE PAPER WASHER when the bearing is
pressed  into position." 
---------------------------------------------------------------------

Elton--
 
The flange on the half-shaft is "dished" in the middle and the  outer flat 
portion will come in contact with the flat face of the hub and  the paper 
gasket which will compress and provide a seal.
 
Best--Michael Oritt