[Healeys] Dropped the engine - source for manifold-carb studs?

Skip Saunders tfsbj7 at mindspring.com
Tue Aug 11 07:38:04 MDT 2009


Upon thinking about my problem, this message contains a hint at the only
explanation that makes sense to me....

I must not have had the lifting bracket tight enough on the rocker shaft.
I've done this engine pull several times, and I know that it is important to
tighten the bracket...

But, this time, I must have just not had it on tight enough.....there must
have been some sort of slop that allowed a bending-shear force to get
applied.  

That is the only explanation that I can come up with...

BTW... the rocker pedestals are all fine... it was only the stud that broke
off ---

Thanks
-skip-

PS...there always has to be a rational explanation...even if it sometimes is
"pilot error"

-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at autox.team.net]
On Behalf Of Bob Yule
Sent: Monday, August 10, 2009 9:36 PM
To: Mirek Sharp; healeys at autox.team.net
Subject: Re: [Healeys] Dropped the engine - source for manifold-carb studs?

    In reply to the question if anyone else has had this happen, then no, we

have not.  However we always tighten the lifting bracket down onto the top 
of the nut holding the rockershaft.  That way there is no slop and no area 
for bending/shearing.  The lifting capacity of the studs is probably many 
times the weight of the power unit.
Cheers.......Bob
Check out our web site www.autofarm.net 
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

You are subscribed as tfsbj7 at mindspring.com

http://www.team.net/archive


More information about the Healeys mailing list