[Healeys] Thanks Rich, But?

[Mark LaPierre]

Thanks for the heads up on that but, How does one reach the nuts for the 
splash panel once the grille assembly is in?  From under the car maybe?

Mark

----- Original Message ----- 
From: "Rich C" <richchrysler at quickclic.net>
To: "'Mark LaPierre'" <lapierrem at sbcglobal.net>; <healeys at Autox.Team.Net>
Sent: Tuesday, April 21, 2009 9:06 AM
Subject: RE: [Healeys] Where Does it Go? Question


> Mark,
>
> These brackets attach onto the bottom left and right studs of the grille
> assembly, along with the tabs of the grille teeth and the bottom of the 
> air
> shroud that directs air to the radiator. It's quite a sandwich of parts 
> that
> all mount to the same studs. These splash shields mount after the grille
> assembly is basically in position. That way the grille teeth assembly can 
> be
> brought in from the side.
>
> Rich Chrysler
>
> -----Original Message-----
> From: healeys-bounces at autox.team.net 
> [mailto:healeys-bounces at autox.team.net]
> On Behalf Of Mark LaPierre
> Sent: Tuesday, April 21, 2009 4:10 AM
> To: healeys at Autox.Team.Net
> Subject: [Healeys] Where Does it Go? Question
>
> Parts manual calls it the "splash panel steady bracket".  ( Page R9 &
> R10,,,,
> #2) There is one for each side of the car.
> One end screws to the lower splash panel,   where does the other end 
> connect
> to?
>
> I have looked in every Healey book that I have and this is a bit of an
> unobtainable area that is
> difficult to photograph with everything intact.
>
> In fact there is a picture of them dangling from the front end of the red
> Healey on the front
> cover of April  Marque magazine.   But of course the one end is not 
> attached
> to anything
> since the shroud is off.
>
> Thanks,  Mark
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler at quickclic.net
>
> http://www.team.net/archive