[Healeys] BJ 8 Clutch Question

[Norman Nock]

John ... Let the slave cyl, hang down on the hose ...put a bleed hose on the
bleed screw put the other end into a jar . NOW with your friends HAND very
slowly press the pedal down 3 or 4 times till no air is coming out the hose
... NOW push the slave cyl. piston back into it's body and tighten bleed screw
... KEEP A CHECK ON THE FLUID IN THE RESERVOIR... bolt the cyl. in place and
pump up the clutch pedal till it feels right           Norman Nock 
PS tell me if you did it this way
TECH TALK by  Norman Nock
  l have been writing technical articles 
for Healey
clubs for over 25 years .
After numerous requests , l have
gathered them
together, along with
some never before published
articles and had them spiral 
bound in book form
       $ 35.00 + $7.50 in USA
        265 pages     Updated
Annually

Both our catalogs are on line and can be down loaded 
www.BritishCarSpecialists.com

209 948 8767

Tech Talk
SAMPLE PAGES ON LINE 
British Car Specialists
2060 N Wilson Way 
Stockton CA 95205
--- On Sun, 4/5/09, STOCKLAND at aol.com <STOCKLAND at aol.com>
wrote:

From: STOCKLAND at aol.com <STOCKLAND at aol.com>
Subject: [Healeys] BJ 8 Clutch Question
To: healeys at autox.team.net
Date: Sunday, April 5, 2009, 9:11 AM

Just replaced the flexible hose to the clutch slave cylinder and now I need 
to bleed the system.  However, I cannot get to the bleed screw.  Is  there
some technique I am missing?  Thanks for your suggestions.

Jon
**************Feeling the pinch at the grocery store?  Make dinner for $10 or
less. (http://food.aol.com/frugal-feasts?ncid=emlcntusfood00000001)
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

You are subscribed as sjnnock at sbcglobal.net

http://www.team.net/archive