[Healeys] Rotors - it happened ....

[NPaul72464 at aol.com]

It seems to me that the electronic ignition company should reduce the  height 
of the magnet sleeve so that they fit intended distributors.
Ned Paulsen
1960 BN7
 
 
In a message dated 8/28/2008 5:01:39 P.M. Eastern Daylight Time,  
price at advocateadvisors.com writes:

Wouldn't  you think someone would make quality rotor that would accomodate 
the  dimentions of an electronic ignition without having to go to your shop and  
grind it?
------Original Message------
From: Dan
Sender:  healeys-bounces+price=advocateadvisors.com at autox.team.net
To:  healeys at autox.team.net
Sent: Aug 28, 2008 2:38 PM
Subject: Re: [Healeys]  Rotors - it happened ....

If you are using a Pertronix system, you need  to grind down the rotor so it
sits farther down on the shaft. I have seen a  few dizzy's where rotors were
not taken down and there is a lot of black  dust inside the dizzy. I saw one
where the center electrode was completely  worn away. Dan Serrao1963  BJ7
_________________________________________________________________
Get  ideas on sharing photos from people like you.  Find new ways to  share.
http://www.windowslive.com/explore/photogallery/posts?ocid=TXT_TAGLM_WL_Photo
_Gallery_082008
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

You  are subscribed as  price at advocateadvisors.com

http://www.team.net/archive


Sent  via BlackBerry by  AT&T
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

You  are subscribed as  npaul72464 at aol.com

http://www.team.net/archive





**************It's only a deal if it's where you want to go. Find your travel 
deal here.      
(http://information.travel.aol.com/deals?ncid=aoltrv00050000000047)