[Healeys] Smitty Conversion- Throw out bearing and arm

[Awgertoo at aol.com]

Lin--
 
I could not view the photo but I believe that the Healey's ventral  
lubrication system combined with the slipstream of air  passing beneath the car will 
take care of this.
 
Hope I see you at Hunt Country tomorrow.
 
Best--Michael Oritt
-----------------------------------------------------------------------------
 
In a message dated 10/13/2007 5:11:05 P.M. Eastern Daylight Time,  
linwoodrose at mac.com writes:

In the  photo below please see points where I assume one would  
use a thin  coat of high temp grease. 1. the shaft that the throw-out  
bearing  rides on and 2. The pivot ball that the arm rotates  against.


 



************************************** See what's new at http://www.aol.com