[Healeys] bellhousing/transmission/overdrive assembly

[Warthodson at aol.com]

There is a "spring plate-bearing" & shim(s) that go between the bellhousing & 
transmission. The purpose is assure there is pressure on the input bearing 
outer race so that does not rotate in the transmission casing. There is a 
similar setup at the rear of the transmission & overdrive. Assuming you have a 
bellhousing, transmission & overdrive that were not original mated together & the 
original shim pack is not available, what is the procedure for determining the 
correct thickness of the spring washer & shim(s) necessary. Is this procedure 
in any of the shop manuals or other Tech. resources?
Gary Hodson



************************************** See what's new at http://www.aol.com