[Healeys] Fw: BJ7 Dimension needed

Elton Schulz eschulz at frontiernet.net
Fri Nov 16 21:00:42 MST 2007


I have yet to receive a reply to my request. Maybe this note did not get on
List, or maybe my request was too confusing. Or possibly the measurement
requested is too difficult to get. So I'm trying one more time in hope that
someone could help. Let me know if clarification is needed.
Thanks,
Elton
----- Original Message -----
From: Elton Schulz
To: Healey List
Sent: Sunday, November 11, 2007 11:59 PM
Subject: BJ7 Dimension needed


Fellow Listers,
Could someone please measure across the width of a BJ7 at the rear quarter
panel finishers, Part no. AHB 9571 and 9572 or Moss part no 805-210 and 220.
This is the little chrome finisher piece at the door shut panel. I need the
distance from the top outside edge of the right finisher across the chassis to
the top outside edge of the left finisher. It should be somewhere in the
neighborhood of 51 inches or so. I would think this would be the same for a
BJ8 as well. I neglected to get this measurement before I replaced the inner
fender doglegs and door shut panels.
Thanks,
Elton, BJ7 in progress


More information about the Healeys mailing list