<!doctype html>
<html>
<head>
<meta charset="UTF-8">
</head>
<body>
<div style="font-size: 12pt; font-family: helvetica, arial, sans-serif; color: #333333;">
<span style="font-family: helvetica; font-size: 12pt;">Oops. I replied to the wrong message.</span>
<br>
</div>
<div style="font-size: 12pt; font-family: helvetica, arial, sans-serif; color: #333333;" class="default-style">
<span style="font-family: helvetica; font-size: 12pt;">Dave</span>
</div>
<blockquote type="cite">
<div>
On 04/26/2023 8:35 PM DAVE HOGYE <dlhogye@comcast.net> wrote:
</div>
<div>
<br>
</div>
<div>
<br>
</div>
<div style="font-size: 12pt; font-family: helvetica, arial, sans-serif; color: #333333;">
<span style="font-family: helvetica; font-size: 12pt;">Here's Jeff's setup. I took this photo at Watkins Glen in 2008 for inspiration and ideas when I was beginning my build. I'm not sure what master he uses. It does not look like TR6, but it is a duel unit that uses the TR3 box and seems to protrude further into the firewall box. This proves that it is possible to build something not too far outside of the standard TR3 setup and if it works for Jeff, it's well tested and performs as needed.</span>
</div>
<div class="default-style" style="font-size: 12pt; font-family: helvetica, arial, sans-serif; color: #333333;">
<span style="font-family: helvetica; font-size: 12pt;">Cheers, </span>
</div>
<div class="default-style" style="font-size: 12pt; font-family: helvetica, arial, sans-serif; color: #333333;">
<span style="font-family: helvetica; font-size: 12pt;">Dave H.</span>
</div>
<blockquote type="cite">
<div>
On 04/26/2023 10:11 AM Scott Janzen via Fot <fot@autox.team.net> wrote:
</div>
<div>
<br>
</div>
<div>
<br>
</div>thx!
<br class="">
<div>
<br class="">
<div class="">
On Apr 26, 2023, at 10:43 AM, Greg Hilyer <<a href="mailto:lunkercars@yahoo.com" class="">lunkercars@yahoo.com</a>> wrote:
</div>
<div class="">
<div class="">
Scott,
<br class="">What I’ve done with Formula Vees is to literally “kick-start” the dyno drum - Get two big guy on both sides of the car to get the drum rolling with foot power. Just a few MPH helps a lot. If need be to get it moving, you can also use the starter motor in first gear (ignition off) for the first couple revolutions (it’s really not as hard on the starter as it sounds), put the clutch in, and let your “mules” kick the best they can.
<br class="">Sounds hokey but if it works for a 50hp Vee it should help your clutch too.
<br class="">Greg “Lunker” Hilyer
<br class="">Albuquerque NM
<br class="">
<br class="">
<blockquote type="cite">
On Apr 25, 2023, at 11:52 AM, Scott Janzen via Fot <<a href="mailto:fot@autox.team.net" class="">fot@autox.team.net</a>> wrote:
<br class="">
<br class="">So, I’m putting together my car with a fresh engine. With a new engine, I almost always spend a few hours on a local chassis dyno - seat the rings, set the timing, check performance, play with carb jets, etc. Way better than showing up at an event with adjustments not made or an engine that blows up on the first run.
<br class="">
<br class="">Anyway, I have a new quartermaster 7-1/4” clutch assembly and flywheel that I would like to put in. However, I have to slip the clutch a lot to get the chassis dyno spooled up, and if I do 5-10 pulls, that’s a lot of clutch slipping. Am I going to toast the new little guy?
<br class="">
<br class="">The alternative, which is of course not very attractive, is to put the full size flywheel/clutch assembly in, do the dyno runs, then pull everything out and swap it. Basically an engine/trans pull, as swapping a flywheel with the engine still in the car and the transmission out just sounds painful.
<br class="">
<br class="">Thoughts?
<br class="">_______________________________________________
<br class=""><a href="mailto:fot@autox.team.net" class="">fot@autox.team.net</a>
<br class="">
<br class="">http://www.fot-racing.com
<br class="">
<br class="">Donate: http://www.team.net/donate.html
<br class="">Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
<br class="">Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/lunkercars@yahoo.com
<br class="">
<br class="">
<br class="">
</blockquote>
<br class="">
</div>
</div>
</div>
<br class="">_______________________________________________
<br>fot@autox.team.net
<br>
<br>http://www.fot-racing.com
<br>
<br>Donate: http://www.team.net/donate.html
<br>Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
<br>Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/dlhogye@comcast.net
<br>
<br>
<br>
</blockquote>
</blockquote>
</body>
</html>