<div style="color:black;font: 10pt Arial, Helvetica, sans-serif;">
<div> <font size="2">Mine are #8 countersunk machine screws, 3 in each half, & the thrust face has an annular groove that's pressure fed, tapped off a small drilling to the rear main.</font></div>

<div><br>
</div>

<div><font size="2">Glen Efinger</font><br>
</div>

<div> <br>
</div>

<div> <br>
</div>

<div style="font-family:arial,helvetica;font-size:10pt;color:black"><font size="2">-----Original Message-----<br>
From: David Cutter via Fot <fot@autox.team.net><br>
To: fot@autox.team.net<br>
Sent: Thu, Feb 23, 2023 10:29 am<br>
Subject: [Fot] Thrust Bearing fabrication question?<br>
<br>

<div id="yiv6954438538">
<div dir="ltr">Amici, fabricating some full 360 degree thrust bearings for the first time.  What is the recommended method for fastening them?  Pin or other fastener?  Fasten both halves or just the upper half?
<div><br>
</div>

<div>Thanks!</div>

<div>Dave</div>

<div>Spitfire #42</div>

<div><br>
</div>

<div><br>
</div>
</div>

</div>
_______________________________________________<br>
<a ymailto="mailto:fot@autox.team.net" href="mailto:fot@autox.team.net">fot@autox.team.net</a><br>
<br>
<a href="http://www.fot-racing.com/" target="_blank">http://www.fot-racing.com</a><br>
<br>
Donate: <a href="http://www.team.net/donate.html" target="_blank">http://www.team.net/donate.html</a><br>
Archive: <a href="http://autox.team.net/archive" target="_blank">http://autox.team.net/archive </a><a href="http://www.team.net/pipermail/fot" target="_blank">http://www.team.net/pipermail/fot</a><br>
Unsubscribe/Manage: <a href="http://autox.team.net/mailman/options/fot/fubog1@aol.com" target="_blank">http://autox.team.net/mailman/options/fot/fubog1@aol.com</a><br>
<br>
<br>
</font></div>
</div>