<html><head></head><body><div class="yahoo-style-wrap" style="font-family:Helvetica Neue, Helvetica, Arial, sans-serif;font-size:13px;"><div dir="ltr" data-setdir="false">I am trying to install the snap rings which hold the wrist (gudgeon?) pins in the pistons. The snap rings I have used on the TR-3/4 engines and most of the other engines I have rebuilt, have small holes in the ends. These allow you to insert snap ring pliers into the holes so you can squeeze the snap rings into place in the grooves in the piston bores.</div><div dir="ltr" data-setdir="false"><br></div><div dir="ltr" data-setdir="false">I am assembling a Ford 1600 CC engine for my Morgan and have bought new pistons. The snap rings that came with these pistons do not have the holes in the ends. See attached picture.</div><div dir="ltr" data-setdir="false"><br></div><div dir="ltr" data-setdir="false">These snap rings are very stiff and I can't squeeze them in by hand. I also can't figure out a way to grip them with the snap ring pliers I have. Does anyone know if there is a special tool I need to use to install these? Or any suggestions about how I should go about installing them? Thanks.</div><div dir="ltr" data-setdir="false"><br></div><div dir="ltr" data-setdir="false">Jack Wheeler<br></div></div></body></html>