<div dir="ltr"><div class="gmail_default" style="font-size:small">IMO, if you have too much end float (without packing) you either have a heavily worn distributor drive gear bush (in the block) or the bottom of the distributor pedestal which bears against the side of the gear is worn.  I have always had to add some "packing" under the pedestal to get end float.  BTW, I never found the instructions in the manual a very accurate way to determine end float. </div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Tue, Mar 19, 2019 at 12:57 AM timmmurphh--- via Fot <<a href="mailto:fot@autox.team.net">fot@autox.team.net</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div lang="EN-US"><div class="gmail-m_-6480941782483154343WordSection1"><p class="MsoNormal">On page 1.130 and 1.131 of the Workshop Manual it describes the procedure for obtaining the correct clearance or float for the distributor gear driven by the camshaft.  It gives two scenarios: one where there is interference of the gear and the bushing; and a second where there is not enough clearance or float.  What it doesn’t consider is if there is too much clearance between the gear and the bushing.  That is the case on my TR4 engine.  I had 0.016 clearance and added a 0.010 shim under the gear to get the desired 0.006 clearance.  Has anybody else had this experience?  And what did you do about it.<u></u><u></u></p><p class="MsoNormal"><u></u> <u></u></p><p class="MsoNormal">Tim Murphy<u></u><u></u></p></div></div>_______________________________________________<br>
<a href="mailto:fot@autox.team.net" target="_blank">fot@autox.team.net</a><br>
<br>
<a href="http://www.fot-racing.com" rel="noreferrer" target="_blank">http://www.fot-racing.com</a><br>
<br>
Donate: <a href="http://www.team.net/donate.html" rel="noreferrer" target="_blank">http://www.team.net/donate.html</a><br>
Archive: <a href="http://www.team.net/pipermail/fot" rel="noreferrer" target="_blank">http://www.team.net/pipermail/fot</a><br>
Unsubscribe/Manage: <a href="http://autox.team.net/mailman/options/fot/johnstydo@gmail.com" rel="noreferrer" target="_blank">http://autox.team.net/mailman/options/fot/johnstydo@gmail.com</a><br>
<br>
<br>
</blockquote></div>