<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META HTTP-EQUIV="Content-Type" CONTENT="text/html; charset=us-ascii">
<TITLE>Message</TITLE>
<META content="MSHTML 6.00.2900.5626" name=GENERATOR></HEAD>
<BODY>
<DIV><FONT face=Arial size=2><SPAN class=750304122-06092008>Greetings
all,</SPAN></FONT></DIV>
<DIV><FONT face=Arial size=2><SPAN class=750304122-06092008>I could use a bit
advice on timing. I have one of the new 1-2-3 distributors out of the
Nederlands.</SPAN></FONT></DIV>
<DIV><FONT face=Arial size=2><SPAN class=750304122-06092008>It's an electronic
distributor with programmable timing curves.</SPAN></FONT></DIV>
<DIV><FONT face=Arial size=2><SPAN class=750304122-06092008>The curve I have at
the moment is 10 degrees at 500 - 1000 , 27 degrees at 2000 and 33 degrees
at 4500</SPAN></FONT></DIV>
<DIV><FONT face=Arial size=2><SPAN class=750304122-06092008>there are 16
different curve settings available. Coming off the throttle it falls flat on
it's face and I have to coax it up to</SPAN></FONT></DIV>
<DIV><FONT face=Arial size=2><SPAN class=750304122-06092008>3000 where it takes
off pretty good. I just installed a set of Mikuni HSR 45's and they ran really
well before I installed </SPAN></FONT></DIV>
<DIV><FONT face=Arial size=2><SPAN class=750304122-06092008>the distributor. I'm
not getting any noticable pinging out of it. I know I still have some jetting to
get through</SPAN></FONT></DIV>
<DIV><FONT face=Arial size=2><SPAN class=750304122-06092008>but as I mentioned,
It didn't have this problem before the distributor went in.</SPAN></FONT></DIV>
<DIV><FONT face=Arial size=2><SPAN class=750304122-06092008>Any advice would be
appreciated.</SPAN></FONT></DIV>
<DIV><FONT face=Arial size=2><SPAN class=750304122-06092008>Jim
Gray</SPAN></FONT></DIV>
<DIV><FONT face=Arial size=2><SPAN class=750304122-06092008>RMVR #
102</SPAN></FONT></DIV></BODY></HTML>