[Fot] Tr6 into Gt6

[Brian Dennis]

 Hi Dennis,Although I run the 2.0L in my spitsix race car the TR6 is the same block and will fit using GT6 mounts. As already stated use the GT6 sump with some mild modification.  I also use the TR6 gearbox with a simple rear gearbox bracket to mount the stock TR6 mount. Driveshaft is a sliding spline yoke MGB shaft with GT6 flanges. The TR6 gearbox flange is simply re-drilled to accept the GT6 flange. Due to the u-joint size I do not recommend dumping the clutch to do burnouts.
Good luck!Brian Dennis

    On Tuesday, May 26, 2020, 12:52:20 PM EDT, Dennis <dennis at motorsportranch.com> wrote:  
 
 
Does anyone have experience with installing anTR6 drive train into a GT6?  I have a 68 MK1 GT6 and would like to install the larger engine. 

Will it fit?  Any modifications needed?

Thanks

Dennis Walje

Sent from my iPhone
_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/britracer89@yahoo.com


  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20200526/fdd7f545/attachment-0003.htm>