[Fot] TR3/4 Rear Main Seal

[Tony Drews]

I did get the message but don't have any alternate suggestions for 
rear seal if the crank is machined for the earlier seal kits.

- Tony Drews

At 06:57 PM 1/20/2017, Joe Boruch via Fot wrote:
>Not sure if this went thru before, since I did not receive it in my 
>inbox and did not receive any replies.  Sorry for the duplication, 
>if it went out previously.
>
>The recent discussion of the valve cover gasket reminded me to ask 
>about TR3/4 rear main seals.  I know that the new improved Viton 
>seals are make to fit cranks that the scroll surface has not been 
>machined.  All my cranks have been machined to fit the earlier seal 
>kits.  Is there an upgraded seal kit to fit machined cranks or would 
>there even be any advantage to using the new seal?  Joe(B)
>
>
>fot at autox.team.net
>
>http://www.fot-racing.com
>
>Donate: http://www.team.net/donate.html
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe/Manage: 
>http://autox.team.net/mailman/options/fot/tony@tonydrews.com