[Fot] TR8 Water temperature

[Mordy Dunst]

 Chris your the engineer....

Heat produced vs heat removed.  There will be a steady state at some point.  You would like it lower.   Don"t underestimate the headgasket component of channeling coolant flow.  In the TR4 motor i made the coolant holes different than original to allow the mass flow of water to occur from the rear of the motor forward.   I also put a pressure gauge on my coolant.  If the pressure is too low it will not cool as efficiently either.  I don"t know what the coolant  dwell time with in the head needs to be to in order to adsorb the heat generated.  Nor the dwell time in the radiator.  There certainly calcs for all this stuff.  

 

MDunst
Headgasket.com
626.628.3777 F
Triple R Munitions, Inc
626.201.9471 T
FFL 6,7 SOT 2



 

 

-----Original Message-----
From: MadMarx <tr4racing at googlemail.com>
To: 'Marcel Van Mulders' <van.mulders.marcel at telenet.be>; 'MadMarx' <tr4racing at googlemail.com>
Cc: fot <fot at autox.team.net>
Sent: Sat, Jul 9, 2016 8:21 pm
Subject: Re: [Fot] TR8 Water temperature



I have a 160F thermostat installed.
Next test will be without any restrictions, maximum flow and see how it goes with that.
 
Chris
 

Von: Marcel Van Mulders [mailto:van.mulders.marcel at telenet.be] 
Gesendet: Samstag, 9. Juli 2016 13:01
An: 'MadMarx' <tr4racing at googlemail.com>
Cc: fot at autox.team.net
Betreff: RE: [Fot] TR8 Water temperature

 
My diesel BMW runs always at 100°C/212°F when hot. What coolant thermostat is in it? If the T° is steady at 212°F, perhaps it  is intentionally done so with a 212° thermostat.
Marcel
 


Van: Fot [mailto:fot-bounces at autox.team.net] Namens MadMarx
Verzonden: donderdag 7 juli 2016 19:21
Aan: 'FOT List'
Onderwerp: [Fot] TR8 Water temperature

Hi guys,
 
My TR8 is running way too hot about 212F at full speed and at idle the temps are getting that high also. I have no idea to get them down.
Radiator core is 68x48cm x 5 cm. I suppose that should be enough. I've experiment with different restrictor plates with no change. Changing pump speed didn't help either. The difference between radiator in and outlet is 10°C (50F). Not enough I would say. Maybe making the pump more slower? It was running on a ratio of 0.8 slower than crank, currently 1:1 speed. Any ideas? 10 Liters are circulating.
 
Cheers
Chris


_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/gasket.works@gte.net



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20160710/0b3449f0/attachment-0001.htm>