[Fot] Weber tuning help please

[Bill Babcock]

If you overtighten the rubber compression mounts they don’t work. 

> On May 3, 2015, at 8:40 AM, Jim Gray via Fot <fot at autox.team.net> wrote:
> 
> I just installed my webers and I’m running into something not covered in anything I’ve read so far.
> At cruise speed which I do on the street, 2500  -3000 RPM my exhaust gas temps on # 4  are 100 plus degrees
> over # 1and will climb to 1400 if I stay at that throttle setting. Under wide open throttle they equalize and seem
> to settle in at about 1300.
> However, I think this may be symptomatic of my other issue. When I’m tuning the idle air screws, open them up until
> it starts to miss & so on, I can get a predictable stumble from three out of the four screws.
> The screw on # 3 has no effect on the idle no matter how far I run it in or out.
> Also , when I put my syncrometers on #’s 3 and 4 they are significantly different.
> I’m not going to get my dyno tune before the first race in two weeks so I’m left to figure it out on my own for now.
> Any help would be greatly appreciated,
> Jim g
>  
> <image002.jpg>
> _______________________________________________
> fot at autox.team.net <mailto:fot at autox.team.net>
> 
> http://www.fot-racing.com <http://www.fot-racing.com/>
> 
> Donate: http://www.team.net/donate.html <http://www.team.net/donate.html>
> Archive: http://www.team.net/archive <http://www.team.net/archive>
> Forums: http://www.team.net/forums <http://www.team.net/forums>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/bill@ponostyle.com <http://autox.team.net/mailman/options/fot/bill@ponostyle.com>
Bill Babcock
Bill at ponostyle.com
Editor: Ponostyle
Celebrating Water

Editor: Xtreme Geezer
Fitness and Fun After Forty
503.936.7660
http://www.PonoStyle.com
http://www.Xgeez.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20150503/db0e8939/attachment-0001.htm>