[Fot] Steel Connecting Rods for a TR6

[Jim Gray]

Irv,
I use them and they have been just fine. However I have been advised to get
the big ends checked for round by a machine shop. I heard someone bought a
set that weren't perfectly round. 
jim g

-----Original Message-----
From: fot-bounces at autox.team.net [mailto:fot-bounces at autox.team.net] On
Behalf Of Irv Korey
Sent: Tuesday, February 25, 2014 8:10 AM
To: FOT
Subject: [Fot] Steel Connecting Rods for a TR6

Good morning, All.

There is a discussion currently on the 6-Pack Forum about steel connecting
rods for a TR6. Specifically, these steel connecting rods:

http://www.ebay.com/itm/181137531371?ssPageName=STRK:MEWAX:IT&_trksid=p3984.
m1423.l2649

The potential buyer is considering these for his street engine because they
are much less expensive than new stock rods. They should also be stronger
and lighter, but I doubt this car will driven hard enough to notice. Is
anyone familiar with this manufacturer? Any experience? I'm familiar with
Carrillo and Pauter, but I'm not familiar with this company. Any other
suggestions/ advice?

Thanks,

Irv Korey
_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/toodamnfunky@comcast.net