[Fot] TR4 Tub Needed

[Glenn Franco]

Group

Just finished a full body off on a TR250 where the previous owners 
should have had their welder & tools taken away it was so bad.

Anyway a TR4 body was purchased by a club member from someone out in PA 
that had *_brazed_* in new panels but obviously didn't know how to read 
a tape measure and control panel warpage. Anyways the panel gaps are 
measured in multiple inches and no straight lines exist between the 
panel due to excessive heat when brazing. Another example of Triumph 
abuse by a D.I.Y. that had no idea what they were doing.

So we are looking for a replacement TR4 tub. Prefer one with minimal 
rust and a non molested body. Body's with rookie panel replacements with 
warped brazed and bondo'd panels need not apply. If panels were replaced 
they should be either plug welded or spot welded in place.

We are located in the Midwest in Michigan.

Please advise and send photo's if you have something available.

Thanks in Advance

Glenn