[Fot] TR4 clutch, help

[Bill Tobin]

Mike, I'm not sure about the TR4, but on my TR6 the slave has to be on the 
back side of the mounting plate, which is mounted on the front of the 
bellhousing.
If it's on the wrong side, you won't get enough travel to disengage the 
clutch.
Like I said, not sure about a 4.
Now if I could just get my brakes bled...........
Good luck, Bill
----- Original Message ----- 
From: "Mike Moore" <mmoore at wave1.net>
To: "'FOT'" <fot at autox.team.net>
Sent: Thursday, May 09, 2013 8:01 PM
Subject: [Fot] TR4 clutch, help


> This is for my race car that I am getting ready for Jefferson 500.
>
>
>
> I had to put in new clutch master (Wilwood 5/8, same as was in car), and 
> new
> slave (stock from Roadster factory.
>
>
>
> With car running when I try to engage gear I have to push clutch all the 
> way
> to floor, works in last half inch, but then the clutch pedal sticks and
> won't come back up.
>
>
>
> I have bled a lot and don't see any more air bubbles.
>
>
>
> Do I need to adjust rods on either cylinder or is it air.
>
>
>
> Thanks
>
> Mike
>
>
>
> Michael T. Moore, CPA
>
> 2007 West 32nd Street
>
> Erie, PA 16508
>
>
>
> Phone: 814-868-4831  ext 103
>
> Fax:        814-864-7383
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/fot/william.tobin31@verizon.net