[Fot] A type O.D.

[19to1tr6 at comcast.net]

Thanks to everyone in response to the OD issues.I finally have a grip on how
it works Currently the Atype is working fine with the car on jack stands. The
articalesB  atB  vtr.org are a grate helpB B  robB 

----- Original Message -----
From: "Larry Young" <cartravel at pobox.com>
To: fot at autox.team.net
Sent: Monday, July 29, 2013 3:04:50 PM
Subject: Re: [Fot] A type O.D.

Steve and Randall,
We didn't include that warning, because I had never heard of coil bind
occurring in these units. B I tested the springs with a valve spring
gauge with a range that didn't allow me to reach coil bind. The
accumulator springs or so stiff (over 500 lb/in) a couple of hardware
store washers will increase the pressure about 50 psi. B I shimmed a
large accumulator OD to about 525 psi with no problems. When the coil
bind happened, what was the shim thickness and what pressure were you
at? B Was it a large or small accumulator? B I will add a warning when we
update the article, but would like the details. B I suppose this would
suggest that you need to bench test it at a speed which is high enough
to activate the relief valve. Otherwise, you have no idea what pressure
you will have at speed.
Larry

On 7/29/2013 1:31 AM, Randall wrote:
> It's a very good article; and yet I wish it had included a copy of Steve's
> warning. B I found out the hard way.
>
> The pressure on the bench and in the car looked fine at lower rpm. B But the
> spring was reaching coil bind at higher rpm and the resulting pressure
> literally bent the bars that the pistons ride against, before eventually
> forcing the clutch assembly out of the carrier. B That big circlip looked
> like a pretzel; and the clutch assembly was pretty much ruined. B The excess
> pressure may also have something to do with the thrust washer exploding, and
> the case being about .080" longer afterSwards.
>
> FWIW, I turned my own adapter for the pressure gauge; a fun but practical
> lathe project. B You can use the plug as a pattern for the OD end, then just
> drill & tap a hole for the pressure gauge (mine was 1/4 NPT).
>
> Randall
_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/19to1tr6@comcast.net