[Fot] TR3/TR4 frame cross brace ADJUSTABLE ALUMINUM CAMBER CONTROL ROD.

[Bob Davis]

Count me in if it fits a TR3 frame.

Bob


On 7/4/12 9:49 PM, Joe Alexander wrote:
> Bob, et.al.
>
> We have the design in place to produce them and have the prototypes on 
> the TR4 #197 and the AMBRO. And they have been on there for several years.
>
> If there was enough interest and advance orders, maybe we could talk 
> Sean into doing a production run.
>
> There is some adjustability available...Kas says he did this by 
> cutting a section out and rewelding.
>
> These are anodized aluminum tubes with heim joints and set up for easy 
> removal to clear the engine block.
>
> Nice looking piece, too.
>
> Sean was mulling over the design so it would fit street cars and clear 
> the fan. That's where the project stalled out. Let me know your 
> interest and I will make a plea to SEAN.  10 POSITVE RESPONSES might 
> do it.
>
> I was estimating about $100 retail for a ready to install kit.  I 
> think there are a couple pictures on photobucket.com/ambro
>
> Thanks for the inquiry
>
> Joe Alexander
> A. R. E.
> 645 1st Street
> Jesup, Iowa 50648
> 319.464.4711  (cell)
> n197tr4 at cs.com
>
>
> -----Original Message-----
> From: Bob Davis <rdavis4 at cfl.rr.com>
> To: fot <fot at autox.team.net>
> Sent: Wed, Jul 4, 2012 8:18 pm
> Subject: [Fot] TR3/TR4 frame cross brace
>
> I recall someone mentioned making the brace between the spring turrets
> adjustable or knew someone selling them made up. Anyone help appreciated.
>
> Bob
> TR3 in progress.
> _______________________________________________
> fot at autox.team.net  <mailto:fot at autox.team.net>
>
> http://www.fot-racing.com
>
> Donate:http://www.team.net/donate.html
> Archive:http://www.team.net/archive
> Forums:http://www.team.net/forums
> Unsubscribe:http://autox.team.net/mailman/options/fot/n197tr4@cs.com