[Fot] TR3/TR4 frame cross brace ADJUSTABLE ALUMINUM CAMBER CONTROL ROD.

[Joe Alexander]

Bob, et.al.

We have the design in place to produce them and have the prototypes on the TR4
#197 and the AMBRO. And they have been on there for several years.

If there was enough interest and advance orders, maybe we could talk Sean into
doing a production run.

There is some adjustability available...Kas says he did this by cutting a
section out and rewelding.

These are anodized aluminum tubes with heim joints and set up for easy removal
to clear the engine block.

Nice looking piece, too.

Sean was mulling over the design so it would fit street cars and clear the
fan. That's where the project stalled out. Let me know your interest and I
will make a plea to SEAN.  10 POSITVE RESPONSES might do it.

I was estimating about $100 retail for a ready to install kit.  I think there
are a couple pictures on  photobucket.com/ambro

Thanks for the inquiry


Joe Alexander
A. R. E.
645 1st Street
Jesup, Iowa 50648
319.464.4711  (cell)
n197tr4 at cs.com




-----Original Message-----
From: Bob Davis <rdavis4 at cfl.rr.com>
To: fot <fot at autox.team.net>
Sent: Wed, Jul 4, 2012 8:18 pm
Subject: [Fot] TR3/TR4 frame cross brace


I recall someone mentioned making the brace between the spring turrets
adjustable or knew someone selling them made up. Anyone help appreciated.

Bob
TR3 in progress.
_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/fot/n197tr4@cs.com