[Fot] TR4 oil galley Acusump plumbing

[Steven Belfer]

I had one of my oil gallery bolt holes in my engine block tapped to  
accept a 3/8 NPT to -10AN fitting.  This was done in the machine shop  
before the block was cleaned.  My machinist said it could be done with  
an assembled motor with thick white grease in the hole to trap metal  
bits from the tapping but I didn't feel comfortable doing it.  I sent  
a picture to Mike of the fitting in the block.  If anyone else wants a  
picture please email me.

~Steve


On May 5, 2010, at 1:32 PM, Mike Mehl wrote:

If I recall there was a thread a few months ago where one of you  
explained how
you adapted the oil galley plugs to manifold your Acusump into the  
galley.  In
fact I recall some one sent me photos.  I have deleted that email.  It  
would
be great if you could resend.

Thanks!!!!

Mike Mehl
_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/fot/colordog.1@earthlink.net