[Fot] Choke Cable

[Chip Collingwood]

Glenn,

You might try using the cable on the rear (2) carbs as Richard suggests, or
you could check with him on his newer (3) cable choke pull setup

Chip


> [Original Message]
> From: Glenn Franco <gaf3 at charter.net>
> To: <tr6parts at charter.net>; Friends of Triumph <fot at autox.team.net>;
<6pack at autox.team.net>
> Date: 3/3/2010 6:15:25 PM
> Subject: [Fot] Choke Cable
>
> With the recent thread on the 6 pack email list, I have a couple of 
> questions for the wisdom of the collective groups.
> Just installed a triple stromberg (Good setup) on a rebuilt early TR6 
> engine with a cam this past fall. The only problem I have is during 
> starting, it takes more than two carbs to start the beast. I need a 
> third cable to connect to the center carb to get it going. after that it 
> runs to problem.
> Any one else had this issue? I have the front and rear carbs on the 
> cable. The center carb is not contributing to the starting event.
> All three carbs were extensively rebuilt including throttle shafts and 
> seals.
> Any ideas out there??
> Thanks in advance
> Glenn Franco
> 3 TR6's , TR250, Spit race car and a nice 76 rust free spit.
> \
> _______________________________________________
> fot at autox.team.net
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
http://autox.team.net/mailman/options/fot/tr6racer21@earthlink.net