[Fot] AN hardware and halfshafts

[gasket.works at gte.net]

I had this issue in the past. I fixed this using using the appropriatly shouldered and sized an6 drilled bolt for saftey wire.  I use a jet nut with (7/16) reduced hex head.  I found that a mac tools closed end /six point wrench works best to hold the jet nut while tightening.  I also use blue loctite.  When completed I use either a cotter pin or safty wire.  In terms of the washer there are two AN type washers.  - I use the thinner.  (Saves weight...)

M
Sent via BlackBerry from T-Mobile