[Fot] TR3/4 engine builders

[Peter Vucinic]

You can usually get felt strips from your local bearing supplier as it is
used as a seal on some design plumber block bearings

Cheers...
Peter V
TR4

-----Original Message-----
From: fot-bounces at autox.team.net [mailto:fot-bounces at autox.team.net] On
Behalf Of Tim Murphy
Sent: Saturday, 31 January 2009 8:49 AM
To: tr3a58 at verizon.net; fot at autox.team.net
Subject: Re: [Fot] TR3/4 engine builders

I ordered some from Moss about a year ago and they were the right size,
rectangular about 1/4 inch by 1/2 inch.

Tim Murphy
1961 TR4 #317

-----Original Message-----
From: fot-bounces at autox.team.net [mailto:fot-bounces at autox.team.net] On
Behalf Of tr3a58 at verizon.net
Sent: Friday, January 30, 2009 3:43 PM
To: fot at autox.team.net
Subject: [Fot] TR3/4 engine builders

   For  the  past  several  years  I have been using Payen gaskets for my
   engines.  I  received a gasket set this week and the felts for packing
   the  rear main cap is way too small. Any body else seen this and where
   can one get proper sized felts?

   Dean T.

   Felt less in Virginia........
Fot mailing list
Fot at autox.team.net
http://autox.team.net/mailman/listinfo/fot
Fot mailing list
Fot at autox.team.net
http://autox.team.net/mailman/listinfo/fot


__________ NOD32 3811 (20090129) Information __________

This message was checked by NOD32 antivirus system.
http://www.eset.com