[Fot] Isihara-Johnson crank scraper - windage tray screen for TR4

steve colordog.1 at earthlink.net
Tue Apr 28 12:42:38 MDT 2009


>It's a TR3 with Carillo rods and a race-prepped stock crankshaft.  I was given the teflon pieces and a tube of blue dye.  I attached everything on the stand and rotated the motor.  Where the blue die rubbed onto the teflon, I trimmed with an X-acto.  again and again until the crank made no contact with the teflon.  With all of those little nuts and washers used to space out the screen and the tray, I made sure everything was tight and wouldn't come apart inside the sump.  Could you imagine a dozen little flat washers dumping into the oil?  Not sure if it would be picked up in the filter.  Anyway, the whole setup took about 6 months to get and was extremely well made.  It seems that tons of guys run the scrapers in Miatas and in many other applications.  There's only one way to find out if the scraper is the culprit and I'm eager to know what you learn when you tear down the motor.
>
>~Steve
>
>-----Original Message-----
>>From: Henry Frye <henry at henryfrye.com>
>>Sent: Apr 28, 2009 11:15 AM
>>To: steve <colordog.1 at earthlink.net>, Henry Frye <henry at henryfrye.com>, fot at autox.team.net
>>Subject: RE: [Fot] Isihara-Johnson crank scraper - windage tray screen for TR4
>>
>>Steve,
>>
>>Is this a TR3/4 motor?
>>
>>What rods are you using?
>>
>>Thanks!
>>
>>Henry Frye - Sent via Phone 
>>860.508.3118
>>
>>-----Original Message-----
>>From: steve <colordog.1 at earthlink.net>
>>Sent: Tuesday, April 28, 2009 2:09 PM
>>To: Henry Frye <henry at henryfrye.com>; fot at autox.team.net <fot at autox.team.net>
>>Subject: Re: [Fot] Isihara-Johnson crank scraper - windage tray screen for TR4
>>
>>I have run four race weekends with my IJ scraper / tray / Teflon setup.  So far no problems.  I am curious to inspect everything but I have no plans to pull the pan for now.  
>>
>>~Steve
>>
>>-----Original Message-----
>>>From: Henry Frye <henry at henryfrye.com>
>>>Sent: Apr 28, 2009 5:10 AM
>>>To: fot at autox.team.net
>>>Subject: [Fot] Isihara-Johnson crank scraper - windage tray screen for TR4
>>>
>>>Racers,
>>>
>>>I am interested in sharing experiences with anyone who bought and has
>>>run one of the Isihara-Johnson crank scraper - windage tray screen
>>>combos for a TR3/4 engine with non-stock rods. I ran mine in my
>>>ill-fated VIR engine build, and while I do not think it caused my
>>>failure I do have concerns...
>>>_______________________________________________
>>>Support Team.Net http://www.team.net/donate.html
>>>
>>>http://www.fot-racing.com
>>>
>>>Fot mailing list
>>>Fot at autox.team.net
>>>http://autox.team.net/mailman/listinfo/fot



More information about the Fot mailing list