[Fot] Subject: Re: TR6 gearbox

[Catpusher at aol.com]

I had the best results setting the end play(s) inside the factory TR2/4/6 
workshop manual specks; keep in mind that this is at room temp.  Loose was not 
good.  Pay attention to optimizing everything, if you have time.
 
TR Regards
 
Hardy
 
In a message dated 10/20/2008 6:58:43 PM Pacific Daylight Time, 
fot-request at autox.team.net writes:

From: Gt6steve at aol.com
Subject: [Fot] TR6 gearbox
To: FOT at autox.team.net
Message-ID: <ca4.3b2b911f.362e58c1 at aol.com>
Content-Type: text/plain; charset="us-ascii"

Amici,
Can anyone point me to a good reference for rebuilding the TR6  gearbox?  I 
broke a spacer in mine this weekend and it has me  wondering.

Do I set it up tight with little endplay in the gears or loose so they slam  
around ?  Where are the critical dimensions and clearances?

I'm using the Moss close ratio gears if that makes any difference...

Steve


**************New MapQuest Local shows what's happening at your destination.  
Dining, Movies, Events, News & more. Try it out 
(http://local.mapquest.com/?ncid=emlcntnew00000002)