[Fot] Replacing TR6 hood
Henry Frye
henry at henryfrye.com
Wed May 7 14:15:54 MDT 2008
I am pretty sure a TR6 is quite similar to a TR4, so maybe this helps.
This is how I do it...
Remove the headlights. Lay the hood in place on car. Reach in the
headlight holes to bolt up the brackets, a couple bolts per side. Open
hood, put the rest of the bolts in. Tighten them a little, but not so
much as the hood can't slide in the brackets. Close the hood, align as
needed, then tighten the bolts some more through the headlight holes so
it can't slide in the brackets. Open the hood, tighten the bolts to
proper torque. Reinstall headlights.
> -----Original Message-----
> From: fot-bounces+henry=henryfrye.com at autox.team.net
> [mailto:fot-bounces+henry=henryfrye.com at autox.team.net] On
> Behalf Of Chuck Arnold
> Sent: May 07, 2008 1:16 PM
> To: Friends; Triumph
> Subject: [Fot] Replacing TR6 hood
>
> Looking to see what tricks people use to re-install the hood
> after engine replacement when done as a one person job. I
> have done it several times, probably try different techniques
> each time, and get frustrated with all of them.
>
> --
> Chuck Arnold
> _______________________________________________
> http://www.team.net/donate.html
>
> Fot mailing list
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
> You are subscribed as henry at henryfrye.com
More information about the Fot
mailing list