[Fot] Installing an oil cooler

[Chuck Arnold]

I have attached a picture for Jim Hearn who asked the question.  It shows my
engine from the side with the plumbing installed.  From it I can tell the
"out" is at the bottom and the in at the top of the adapter.  Does not show
the thermostat.  Does show a "T" I installed at the in  port. From the top
of the T one side goes to a feed to the number one cylinder oil galley.  The
other side goes to the accusump.



On Jan 26, 2008 8:17 PM, jim hearn <jimhearn1 at comcast.net> wrote:

> I am installing an oil cooler with the spin on oil filter adapter on my
> TR6.
> When it comes to putting the thermostat in line, the directions say to see
> which line has the oil flowing from the engine.  Since this car is only
> for
> racing, I wasn't going to put any oil in it for another month or so.  Can
> anyone please tell me which outlet on the adapter (top or bottom) has the
> oil flow from the engine?  I would expect it to be the top one since the
> bottom outlet (in this case inlet) flows directly to the filter.  Does
> anyone know if this is correct?
>
> Thanks, Jim
> Two 1974 TR6s
>
> [demime 1.01d removed an attachment of type application/ms-tnef which had
> a name of winmail.dat]
> _______________________________________________
> http://www.team.net/donate.html
>
> Fot mailing list
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>



-- 
Chuck Arnold

[demime 1.01d removed an attachment of type image/jpeg which had a name of engine side viewer no meter unit1.JPG]