[Fot] TR6 piece between radiator and motor

[N197TR4 at cs.com]

Exactly, Glen.  

Once again, my camber was set before I installed this adjustable bar.  This 
would only serve to fine tune if that was important to me.  I would not install 
this solely to use in adjusting camber.  

Larry Young has calculated that it would take .7" of movement at the top of 
the tower on each side to effect 4 degrees of camber change.

My final adjustment is relatively small and within a tolerable range, 
methinks ...especial if one considers that this has been done successfully in the 
past by sectioning the tube to shorten.

Regards,

Joe



  

> "People might have differing opinions about this method of camber 
> adjustment"
> 
> ... well that much I agree with...!
> 
> Glen
> 

   </HTML>