[Fot] TR4 Headers

[Greg & Alison Blake]

Try Stahl.  http://www.stahlheaders.com/ When I was asking around about
6 months ago, some on the list recommended them.  My project has stalled
somewhat so I have not purchased yet.

I am still looking also if anyone has a set to sell.

Thanks,

Greg

-----Original Message-----
From: fot-bounces+ablake2=austin.rr.com at autox.team.net
[mailto:fot-bounces+ablake2=austin.rr.com at autox.team.net] On Behalf Of
Cofrog at aol.com
Sent: Sunday, September 23, 2007 11:21 AM
To: FOT at Autox.Team.Net
Subject: [Fot] TR4 Headers

I am needing to replace the headers on my TR4A due to the flange
thickness  
on the current ones being about half the flange thickness of the intake 
manifold  flange where both mount to the head.  Some tabs have been
welded to  the 
flange of the header where the mounting points are to accommodate the
thickness 
discrepancy  But I am experiencing cracks in the intake manifold  and
blame 
this on the above.
 
I did some track time last week to test a new motor and another intake  
manifold crack appeared.  I have applied some JB Weld to it and loosened
the 
mounting hardware by it.  Hoping this "fix" will hold for the RMVR
event nest 
weekend.  Any input? 
 
Has anyone had any experience with the headers that the big three  sell?
Or 
does anyone have a good set of headers that they want to  sell?
 
Thanks,
 
Dan Forgey



************************************** See what's new at
http://www.aol.com
ablake2 at austin.rr.com
Fot mailing list
Fot at autox.team.net
http://autox.team.net/mailman/listinfo/fot