[Fot] dual circuit brakes on a tr4

[Bill Babcock]

It's not a balance vbalve, it's a residual pressure valve.


-----Original Message-----
From: fot-bounces+billb=bnj.com at autox.team.net on behalf of
WEmery7451 at aol.com
Sent: Fri 11/2/2007 9:34 AM
To: markvaden at gmail.com; fot at autox.team.net
Subject: Re: [Fot] dual circuit brakes on a tr4

In a message dated 11/1/07 2:50:08 PM Pacific Standard Time,
markvaden at gmail.com writes:

<< Does anyone have a suggestion on bore sizes to start with. I am running
stoc
k TR4 front and rear brakes.>>

When I installed the Revington system several years ago when a dual system
was required, two standard TR-3/4 brake master cylinders were furnished,
along
with a TR-4 clutch master cylinder (with the reservoir).  Revington's
instructions at that time said that no smaller bore master cylinders were
made.
  Now I
have heard that Tilton and others may make the smaller bore brake master
cylinders.

I was surprised the first time out on the track with this system.  I had to
push the brake peddle a lot harder to get the same effect.  It didn't take
long
to get use to this requirement, and in my opinion the system works very well.
 Don't accidentally take out that little balance valve for the front disc
brakes.
**************************************
 See what's new at http://www.aol.com
Fot mailing list
Fot at autox.team.net
http://autox.team.net/mailman/listinfo/fot