[Fot] Rod Bearing issue

[Jack Brooks]

Mark,

Is it possible that #1 big end isn't getting enough oil?  I know the engine
oil pressure is good, but perhaps there is a restricted passageway coming
out of the crank.

Also, what does the wear look like?  Is it even across the journal or offset
to one side?  

This is purely conjecture on my part.  I have not experienced uneven wear
like you described.

Jack

-----Original Message-----
From: fot-bounces at autox.team.net [mailto:fot-bounces at autox.team.net] On
Behalf Of mark eginton
Sent: Tuesday, May 15, 2007 4:56 AM
To: Fot at autox.team.net
Subject: [Fot] Rod Bearing issue

This may be one of those questions like "what's up with women" but I am
regrinding a crank on a street TR 3 engine that wore out big end bearing #1
while all the others and the mains look like new. Its clearly not a bent
rod, been there on a Ford. Can't figure out why just the one journal would
wear? Anything I should check before putting in the reground crank?
   
  The car has always had an oil pressure issue 70psi cold, 20 psi hot, 15
really hot. It was this way through two engines from bran new to... Thought
it was the gauge but never really investigated. Ran 30 wt GTX ->  40 wt when
they start to smoke. Last decade or so I have been running 20 50 GTX.
Followed the oil emails all winter but I can't imaging that the additives
would affect oil pressure.
   
  Finally, having problems finding tri-metal bearings at 30 over, are they
that important in a street engine?
   
  Thoughts???
   
  M

       
---------------------------------
Get the Yahoo! toolbar and be alerted to new email wherever you're surfing. 
jibjib at att.net
Fot mailing list
Fot at autox.team.net
http://autox.team.net/mailman/listinfo/fot