[Fot] Spitfire Headers

[Greg & Alison Blake]

Has anyone used the Stahl TR4 header for the 3 or 4?

-----Original Message-----
From: fot-bounces at autox.team.net [mailto:fot-bounces at autox.team.net] On
Behalf Of Glenn Franco
Sent: Tuesday, June 26, 2007 6:08 PM
To: Russ Moore
Cc: fot at autox.team.net
Subject: Re: [Fot] Spitfire Headers

Russ Moore wrote:
> Stahl is the only way to go!
> Anything else is a waste of money. The stock Mk2 is not bad for an
1147, but 
> you'll never regret the Stahl once you put it on. You will need to cut
out a 
> portion of the belhousing and the rear engine plate, but it's worth
it. You 
> will notice the difference.
>
> Russ Moore
>
> ----- Original Message ----- 
> From: "Norlin Engineering" <norlinengineering at comcast.net>
> To: <fot at autox.team.net>
> Sent: Tuesday, June 26, 2007 1:55 PM
> Subject: [Fot] Spitfire Headers
>
>
>   
>> Does anyone know of a ready source for Spitfire headers that will
stay
>> tucked up in the frame?  This is for a 1300 and the engine builder
says I
>> should stick with a  tri wye design for the prep level of the motor
he's
>> building.  The headers available from the sources I've found so far
are
>> apparently for street cars since they hang 1 1/2 to 2 inches below
the
>> frame.
>>
>> Thanks
>>
>> Jim Norlin
>> _______________________________________________
>> http://www.team.net/donate.html
>>
>> rem9 at frontiernet.net
>> Fot mailing list
>> Fot at autox.team.net
>> http://autox.team.net/mailman/listinfo/fot
>>     
> _______________________________________________
> http://www.team.net/donate.html
>
> gaf3 at charter.net
> Fot mailing list
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
>
>   
I also have a set of Stall headers and I have an interference with the 
dipstick tube as well.
Glenn
72 spit racer under construction
ablake2 at austin.rr.com
Fot mailing list
Fot at autox.team.net
http://autox.team.net/mailman/listinfo/fot