[Fot] TR4 IRS differential disassembly

[Bob Bownes]

And don't let the end caps get swapped...

On Mon, 09 Jul 2007 05:32:56 -0500, Jack W. Drews wrote
> Sure. I've taken quite a few apart and have had to use a case 
> spreader tool only once or twice. The odds are that you can remove 
> the diff without it. You take off the rear cover and turn the diff 
> carrier so that the open sides of the casting are on the top and 
> bottom, as viewed from the rear of the car. Then you take two long 
> screw drivers or similar pry bars, stick the ends into the cavities 
> of the carrier, and pry it right straight out. You can usually move 
> it far enough that you can then get your fingers in there and lift 
> it the rest of the way out.
> 
> At 10:59 PM 7/8/2007, you wrote:
> >I'm installing ( or trying to install ) a Phantom Grip LSD device in my
> >IRS diff. Does anyone know the proceedure for disassembling
> >the differantial with conventional tools ?
> >Jim Gray
> >Aurora, Co.
> >_______________________________________________
> >http://www.team.net/donate.html
> >
> >vinttr4 at geneseo.net
> >Fot mailing list
> >Fot at autox.team.net
> >http://autox.team.net/mailman/listinfo/fot
> 
> uncle jack
> 
> ------------------------------------------------
> No Virus Found In This Message
> Scanned at barracuda.geneseo.net
> _______________________________________________
> http://www.team.net/donate.html
> 
> bownes at web9.com
> Fot mailing list
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot



iii