[Fot] TR4 IRS differential disassembly

[Jack W. Drews]

Sure. I've taken quite a few apart and have had to use a case 
spreader tool only once or twice. The odds are that you can remove 
the diff without it. You take off the rear cover and turn the diff 
carrier so that the open sides of the casting are on the top and 
bottom, as viewed from the rear of the car. Then you take two long 
screw drivers or similar pry bars, stick the ends into the cavities 
of the carrier, and pry it right straight out. You can usually move 
it far enough that you can then get your fingers in there and lift it 
the rest of the way out.

At 10:59 PM 7/8/2007, you wrote:
>I'm installing ( or trying to install ) a Phantom Grip LSD device in my
>IRS diff. Does anyone know the proceedure for disassembling
>the differantial with conventional tools ?
>Jim Gray
>Aurora, Co.
>_______________________________________________
>http://www.team.net/donate.html
>
>vinttr4 at geneseo.net
>Fot mailing list
>Fot at autox.team.net
>http://autox.team.net/mailman/listinfo/fot

uncle jack 



------------------------------------------------
No Virus Found In This Message
Scanned at barracuda.geneseo.net