[Fot] TR6 motor rebuild

[Joe Boruch]

I have been using Pauter rods in may TR3 and they have worked very well.
Priced much lower than Carillos, but made from the same steel and same forge
as Carillos.  Joe(B)

-- "U K MOTORSPORTS" <tr6racer21 at earthlink.net> wrote:
Charly

Try these http//www.pauter.com/ , http//www.jepistons.com/
Chip


> [Original Message]
> From: Charly Mitchel <charly at mitchelplumbing.com>
> To: Friends <fot at autox.team.net>; Chuck Arnold <triosan at gmail.com>
> Date: 12/14/2007 1:54:14 AM
> Subject: [Fot] TR6 motor rebuild
>
> FoT,
> I'm starting the rebuild on another TR6 racing motor and I'm looking for a
> little input as to which parts I should be using.  I'll be running a CR of
> about 11.5:1, have a KB cam and a stock crankshaft with Cambridge
flywheel.
> I'll be using the Lucas PI setup and will have a Tilton clutch.
> I know I'll need to go to some better pistons than stock and will
probably use
> Venolia pistons.
> Anybody got any suggestions on pistons and rods?  Is there a connecting
rod
> from another manufacturer that will take the place of a TR6 rod that is
> better?
> Thanks
> Charly Mitchel
> TR6 #44
> _______________________________________________
> http://www.team.net/donate.html
>
> Fot mailing list
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.503 / Virus Database: 269.17.1/1183 - Release Date:
12/13/2007 9:15 AM
Fot mailing list
Fot at autox.team.net
http://autox.team.net/mailman/listinfo/fot

_____________________________________________________________
Click to shop and compare great deals on trucks.
http://thirdpartyoffers.netzero.net/TGL2211/fc/Ioyw6ijlMsqkSpl6uP1OgDoZYd9CvJ
JJh5CJFTjeDThQCGzr5RbEth/