[Fot] TR3 bore sizes?

[A Daniel Cronin]

Had an email comunication with Ken late last week to see if he had 92's and his response was that he did not due to difficulties with machining, etc.

Bill Babcock <BillB at bnj.com> wrote:  Yup, Ken gillanders has nice flat top wisecos and sleeves from LA Sleeve. I'm
going to use the 92mm in my street TR3.

-----Original Message-----
From: fot-bounces+billb=bnj.com at autox.team.net on behalf of Mark J. Bradakis
Sent: Tue 8/28/2007 9:00 PM
To: FOT at autox.team.net
Subject: [Fot] TR3 bore sizes?

So this local club member brings in his TR6 for some work (stuck
Grose Jet in rear carb) and we start talking about his TR3 project.

Can 89 mm piston sets be had that will make a reliable, streetable
motor?

mjb.
billb at bnj.com
Fot mailing list
Fot at autox.team.net
http://autox.team.net/mailman/listinfo/fot
adcronin at ameritech.net
Fot mailing list
Fot at autox.team.net
http://autox.team.net/mailman/listinfo/fot



Planning & Development Services
A. Daniel Cronin
248 761-2673