[Roadsters] window channel rubber
Mark Sedlack
msedlack at neo.rr.com
Mon Mar 25 10:46:16 MDT 2013
For the u-channel with fuzzy inside that runs the length of the window
channel from the top of the vent frame to the bottom of the that rail inside
the door, then one of these, from JCWhitney, is what I used very
successfully on our '66. I don't recall which one, but measure the bare
channel, and compare the dimesions - one of these was a good press-fit into
the channel. It did need to be cut with a hacksaw / cut-off wheel to be the
right length.
http://www.jcwhitney.com/stanpro-window-channel/p3070832.jcwx?filterid=u0j1
Mark Sedlack
New Franklin, OH
66 1600 http://www.mildevco.net/chevypowereddatsuns/
77 280Z http://www.mildevco.net/chevypowereddatsuns/
----- Original Message -----
From: "dave n" <sumton at sbcglobal.net>
To: "Datsun" <datsun-roadsters at autox.team.net>
Sent: Sunday, March 24, 2013 1:58 AM
Subject: [Roadsters] window channel rubber
> early 67 low windshield roadster
>
> the rubber channel that fits into the back of the vent window b the
> rubber
> that the roll up window goes up and down in
>
> I need that. I was told there are suppliers of generic channel I could
> use?
>
> can anyone lead me in the right direction?
>
> thanks!
> ________________________________________
>
> datsun-roadsters at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/datsun-roadsters/msedlack@neo.rr.com
More information about the Datsun-roadsters
mailing list