[Roadsters] early 67 roadster pedal assembly

[robert k. smith]

hi dave, i usually just tighten the nut really tight(mabe use some
loctite),
and adjust the cable where the pedal hits the floor(or stop), before the
carb. butterfly is all the way open, and starts binding the cable. that way
it
wont bend the pedal arm.  once you adjust the cable properly, it wont be
putting force against the pedal linkage.    best of luck,  bob smith, ohio

> From: dave at ranteer.com
> To: datsun-roadsters at autox.team.net
> Date: Fri, 20 Dec 2013 20:18:33 -0600
> Subject: [Roadsters] early 67 roadster pedal assembly
>
> hi, all.
>
> put the carpet in, and realized that it really limited accelerator pedal
> travel.  then I realized it was no longer  a tight fit on the linkage shaft
> that it bolts to.  then I realized that even without the carpet, it doesn't
> really get full travel.
>
> do I have the pedal bent at a more upward angle?
>
> suggestions?  surely I'm not the first to encounter this.
> ________________________________________