[Roadsters] Rocker Panel End caps-1968 311

[Mark Sedlack]

Halfway down this page I have pics showing how to easily make the part with 
a piece of sheet steel and a couple of weld-nuts from Ace hardware:
http://www.mildevco.net/chevypowereddatsuns/body_prep.htm  Since you're 
asking about a patch panel, I assume you can ( or know someone who can ) 
weld.  From the ones I've seen, the rounded portion toward the front usually 
doesn't rust, just the part that was in contact with or close to the fender.

Mark Sedlack
New Franklin, OH
66 1600 http://www.mildevco.net/chevypowereddatsuns/
77 280Z http://www.mildevco.net/chevypowereddatsuns/


----- Original Message ----- 
From: "norman pitcher" <ndpsail at yahoo.com>
To: <datsun-roadsters at autox.team.net>
Sent: Tuesday, August 21, 2012 7:40 AM
Subject: [Roadsters] Rocker Panel End caps-1968 311


>I need to replace the rusted rocker panel front/rear end caps. Is there a
> source of end caps other than the $380+ from Australia? Would appreciate
> anyone's other end cap replacement options
> Thanks
> ________________________________________
>
> datsun-roadsters at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: 
> http://autox.team.net/mailman/options/datsun-roadsters/msedlack@neo.rr.com