[Roadsters] Need screw sizes

[Ronnie Day]

 Thanks, Pat. I should get the carpet kit in this weekend. Elayne' on a
quilting weekend in Stonewall. May get thte rear drums off, too. One side
is dragging. I have new wheel cylinders just in case. May also need shoes.
I'd like to sell the car, hopefully to someone who'll take care of it. I'm
going to focus on my 510s. More practical for us older folks, IMO. Corky
Bell has offered to help. That should be a lot of fun.

How are you guys? Since my heart attack in January, I was doing well until
I tore up my knee, but they can't fix that while I'm on Plavix. May in the
fall. Hope to be in the house in three or four months, if I don'd fall
apart first!

Later

On Thursday, April 12, 2012, Ronnie Day <ronnie.day at gmail.com> wrote:
> Okay folks, I need a few screw sizes. Car is a '70 2000. I need the
size(s) that hold the trim panels under the dash above the knees, and the
size(s) that hold the vertical panels on to either side of the center dash
extension. I also need the thread size for the screws that fasten the pull
handles to the doors. Looks like I'm going to need to drill an old screw
out and re-thread. Are all of these sizes listed on the parts diagrams?
> TIA,
> Ron