[Roadsters] Intake manifold question

Pete Peters ppeters914 at comcast.net
Tue Aug 23 13:03:52 MDT 2011


I was told (don't remember who or when) that those holes were from the casting/manufacturing process. The plugs are just that; plugs. Never seen a pic w/ 'em connected by hose or tubing. 

Pete 

----- Original Message -----
From: "oliver" <sumton at sbcglobal.net> 
To: "Datsun" <datsun-roadsters at autox.team.net> 
Sent: Tuesday, August 23, 2011 9:36:59 AM 
Subject: Re: [Roadsters] Intake manifold question 

no, these are just the engine side of the carbs. 

if you look at this picture http://tinyurl.com/3l3hpyt 

the little bolt head is very evident on the left (front) manifold halfway 
between the head and the carb. 

apparently this opening is supposed to be connected via hose to the 
right/rear manifold for balance 

-------------------------------------------------- 
From: "John F Sandhoff" <sandhoff at csus.edu> 
Sent: Tuesday, August 23, 2011 11:31 AM 
To: "oliver" <sumton at sbcglobal.net> 
Cc: <datsun-roadsters at autox.team.net> 
Subject: Re: Intake manifold question 

> 
>> My intake manifold (early 67 roadster) has matched holes on each 
>> side which are filled in by a bolt.. 
>> 
>> I just saw another manifold which has what I am assuming to be a hose 
>> assembly which apparently acts as a kind of balancer between the two. 
> 
> Are these threaded fittings on top of the runners? Sure sounds like the 
> fittings for the smog pump plumbing, which would indicate that your 
> car experienced a manifold swap somewhere along the way... 
> 
> -- John 
> John F Sandhoff sandhoff at csus.edu Sacramento, CA 
________________________________________ 

datsun-roadsters at autox.team.net 

Donate: http://www.team.net/donate.html 
Archive: http://www.team.net/archive 
Forums: http://www.team.net/forums 
Unsubscribe: http://autox.team.net/mailman/options/datsun-roadsters/ppeters914@comcast.net 


More information about the Datsun-roadsters mailing list