[Roadsters] brake bleeding woes

[Andy Cost]

I've had problems with air bubbles in the master cylinder.  The master
cylinder slopes up away from the driver.  A bubble can get in the very end.
All the bleeding in the world wouldn't get it out.  My solution was to take
the front wheels off and set the front end almost on the ground.  I then
jacked the rear of the car several feet up.  I think I either backed the
rear wheels onto the trailer or I used my engine crane to pick the rear up.
Anyway, I jacked it up in the rear until a torpedo level on the master
cylinder showed it was sloped slightly the other way.  A few pumps with the
bench bleeder screws open and a large bubble made its way through the tube.
Then the brake pedal was very stiff.

Andy

-----Original Message-----
From: datsun-roadsters-bounces at autox.team.net
[mailto:datsun-roadsters-bounces at autox.team.net] On Behalf Of steven boortz
Sent: Thursday, March 04, 2010 12:11 AM
To: datsun-roadsters at autox.team.net
Subject: [Roadsters] brake bleeding woes

Hi everyone

I just don't get it. How can I have clear bubble-less fluid out of all 8
bleeder screws, and still no pedal?  Bad (new) master cylinder?

I have volvo calipers in front. Last time out brakes were fine. Took them
apart to add cooling ducts. Re-assembled and tried to bleed system, but m/c
leaked out the back. Replaced with NOS aftermarket m/c.

Thanks for your help
S
675MIZU
________________________________________
Datsun-roadsters at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $16.00
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/andycost@embarqmail.c
om