[Roadsters] (no subject)

[E Scanlon]

I apologize for the misunderstanding as well. Re-reading your original post, 
I obviously jumped to a different conclusion, hence my reply.

That one is also a pain to get to, but thankfully not as much as the water 
one.

When I refurbished mine, the screws holding it in place sheared off flush 
with the base.  It can be quite a chore drilling and tapping the mounting 
nuts to get a new screw in there. You might want to check those before you 
install your replacement part.

Good Luck
Enrique


----- Original Message ----- 
From: "The Bankers"
Sent: Friday, September 11, 2009 4:00 AM
Subject: [Roadsters] (no subject)


>I was not clear when I said I needed a heater valve for my 66.  I am 
>looking
> for the heater AIR valve, not the coolant/water valve.  This is the valve 
> that
> controls the amount of outside air into the cabin area and is roughly 3" 
> in
> diameter and is connected to the heater controls via cable.  It mounts 
> with
> four small screws.  Mine is rotted so the hinge is gone.  Under the 
> Rallye
> website, it is listed as part #271-10.
>
> Sorry about the confusion and I am still looking for one.
> ________________________________________