[Roadsters] Ball joint taper

[Graeme]

Lower BJ has the following dims: -
large diam. = 17mm[0.669"]
small diam. = 15mm[0.590"]
taper length = ~19mm[~0.75"]
: )
 

-----Original Message-----
From: datsun-roadsters-bounces+graemes=internode.on.net at autox.team.net
[mailto:datsun-roadsters-bounces+graemes=internode.on.net at autox.team.net] On
Behalf Of Andy Cost
Sent: Wednesday, 3 October 2007 7:24 AM
To: datsun-roadsters at autox.team.net
Subject: [Roadsters] Ball joint taper

Does anyone have information about the lower ball joint shaft taper?  How
about a dimensioned drawing?  I'm working on the race car and need some
information before going custom.

Andy
________________________________________

graemes at internode.on.net

Datsun-roadsters mailing list

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/datsun-roadsters

No virus found in this incoming message.
Checked by AVG Free Edition. 
Version: 7.5.488 / Virus Database: 269.13.37/1042 - Release Date: 1/10/2007
6:59 PM
 

No virus found in this outgoing message.
Checked by AVG Free Edition. 
Version: 7.5.488 / Virus Database: 269.13.37/1042 - Release Date: 1/10/2007
6:59 PM